Hi,
Anyone out there experience micro scratches caused by changing EBR from 2mm to 3mm on incoming thick Cu layer? Could the wider EBR allow for more slurry agglomeration that cause scratches?
Ed Read More>> |
Dear All,just to inform you that CMP Consulting has been updated with new tabs, with a press release tab.Thanks to all who gives postings, writings, presentations that can help the CMP community to go further on. Read More>> |
Dear All,
here we are! Unfortunately, after a "fight" with my previous hoster and a Domain transfer required, this one had blocked the transfer. Thus, the transfer was cancelled and a new Domain was opened.
Please, change your favorites to: http://www.cmpconsulting.fr
Best Regards
Your Favorite Webmaster
Read More>> |
Dear All,
CMP Consulting is hosted at Mon Hosteur but the host has been hijacked on the 24th of August and lots of sites were lost as CMP Consulting.
Today, CMP Consulting is offline because I'm in dispute with the hoster Mon Hosteur because they never advise that there was an issue and lots of site were offline.
A new hoster was found and I'm waiting for the transfer of the domain in order to keep the same name and the same email address.
Read More>> |
Dear All,
CMP Consulting has been updated. Only a few changes on the library page. There will be soon more topics in order to continue on CMP Consulting objective and become the greatest library for CMP.
But, I need your help. If most presentations comes from events, I'm sure that there are topics, needed for CMP community, that are "sleeping" in some drawers and that can be put online. So, please, check if some presentations, papers and Topics can be put online. It's not only my website, but, it's OUR library where we can refere if needed.
Read More>> |
|
|
|
Message Board (2)
For silica nano-particles,
For silica nano-particles, typical sizes range from 15 to 50 nm, although people have been using them in the range of 15 to 35 nm.
As for price, it depends mostly on purity levels of the colloidal (or precipitated) solution as well as on solids content. Of course, the smaller the particle, the less the solids content (due to stroonger particle-particle repulsive forces). Ultra pure systems (like those offered by Fuso in Japan) can cost 4 to 10 times more than the less pure ones such as those offered by Clariant and others.
How much typically do